%
O6 ( INSERT YOUR NAME AND LAB NUMBER HERE)
(READ THESE INSTRUCTIONS FIRST)
(THIS IS PROGRAM TEMPLATE FOR MOLD PROJECT )
(MUST USE ALL CAPITAL LETTERS)
(FOLLOW THE INSTRUCTIONS CONTAINED IN THE COMMENTS BELOW)
(NOTE YOU CAN DELETE THE COMENTS IN PARETHESIS IF YOU WISH)
(THEY ARE ONLY THERE AS A GUIDE)

L200 (START OF  DOWEL HOLE SUBROUTINE)
G0 (INSERT X-Y LOCATION OF FIRST DOWEL HOLE)
(INSERT X-Y LOCATION OF SECOND DOWEL HOLE) 
(INSERT X-Y LOCATION OF THIRD DOWEL HOLE)
(INSERT X-Y LOCATION OF FOURTH DOWEL HOLE)
G80 M5 (CANCELS DRILL CYCLE)
M17 (END OF SUBROUTINE FOR HOLE MAKING)

L300 (START OF CENTERLINE SUBROUTINE)
(LEAVE THIS SUB ALONE)
G0 X0 Y4.
G1 Z-.025 F20.
Y-.5
G0 Z.1
M17 (END OF SUBROUTINE FOR CENTER LINE)

L400 (START OF CONTOUR SUBROUTINE)
G0 (TOOL START POSITION IN X AND Y) 
G1 Z-.100 F10. (MOVE CUTTER TO PROPER Z-DEPTH OF CUT)
(NOW WRITE OR INSERT ALL THE MOVES IN THE CONTOUR FROM START TO FINISH)
(DON’T FORGET TO TURN ON AN TURN OFF CUTTER COMP WHERE NEEDED)
G0 Z.1 ( RAISE CUTTER UP)
M17 (END OF  CONTOUR SUBROUTINE)
M30 ( CODE FOR END OF ALL SUBROUTINES)

(DO NOT CHANGE TOOL INFORMATION BELOW EXCEPT FOR TOOL-5 SUB CALLS IF NEEDED)
M6 T3  (TOOL CHANGE TO TOOL-3)
(TOOL-3  CENTER DRILL)
G0 G90 G70 G40 S1500 M3 E1 (MACHINE START UP CODES)
H3  Z.10 (TOOL LENGTH OFFSET AND Z POSITION FOR T3)
G81 G99 R0+.1 Z-.2 F10.0 ( CANNED CYCLE TO DRILL)
L201 (CALL DOWEL HOLE SUBROUTINE L200 ONE TIME)
M6 T4  
(TOOL-4  15/64 DRILL)
G0 G90 G70 G40 S3000 M3 E1
H4 Z.10
G83 G99 R0+.1  Z-.6 Q.1  F20.0 (PECK  DRILL CYCLE)
L201 (CALL DOWEL HOLE SUB ROUTINE L200)
M6 T6 
(TOOL-6. 250” REAMER)
G0 G90 G70 G40 S1500 M3 E1
H6 Z.1
G81 G99 R0+.1 Z-.6 F10.0 ( DRILL CYCLE))
L201 (CALL DOWEL HOLE SUB ROUTINE L200)
M6 T3 ( USE T3 TO SCRIBE CENTER LINE)
G0 G90 G70 G40 S3000 M3 E1
H3 Z.1
L301 (CALL SCRIBE SUBROUTINE L300)
M6 T5  
(TOOL-5 3/8” DIA. END MILL)
G0 G90 G70 S3000 M3 E1 
H5 D5 Z.1 (D = TOOL OFFSET NUMBER)
L401 (CALL CONTOUR SUB ROUTINE L400)
M6 T1
X0 Y0
M2 (END OF PROGRAM)
%